Stretch film is the final layer of security on a pallet. Done correctly, it anchors the load to the pallet deck, holds boxes together against lateral forces, and protects the outer layer of cartons from moisture and dirt. Done incorrectly, it creates a false sense of security while the load shifts freely inside the film.
This guide explains the right way to apply stretch film manually, how much film you need, and the mistakes that undermine an otherwise well-prepared pallet.
What You Need
- Machine-grade or hand-grade stretch film (minimum 17 microns thickness for manual application; 23 microns provides better tear resistance)
- A hand wrap dispenser (reduces fatigue and improves tension consistency)
- Corner protectors (optional but recommended for heavy loads or loads with sharp box edges)
Step-by-Step Wrapping Process
- Start at the base. Attach the film to one of the pallet's lower legs or loop it through the pallet deck to anchor it. This first anchor pass is critical — without anchoring the film to the pallet itself (not just the goods), the load can slide off the pallet deck.
- Apply two to three base passes. Walk around the pallet keeping tension on the film, overlapping each pass by at least 50%. Keep the film low, wrapping around both the bottom of the boxes and the pallet deck itself.
- Work upward in an overlapping spiral. Move up the load with each circuit, overlapping each layer by half. This creates a solid bond between layers rather than a series of independent bands.
- Cap the top. Once you reach the top of the load, fold the film over the top layer and wrap back down towards the base in the same spiral pattern. This prevents rain or debris from entering through the top.
- Finish with two anchoring passes at the base again. Secure the film end by tucking it under a previous layer or pressing it firmly against itself — the stretch film's natural cling will hold it in place.
How Many Layers?
Most loads need three to four complete passes of film at each height level, working out to two to three full rolls (500-metre rolls) for a standard Euro pallet loaded to 100–200 cm. Heavier loads or longer journeys warrant additional film.
A good test: try pushing the load sideways with moderate force once wrapped. The load should feel firm, not flex. If it moves, apply more film at the base and mid-sections.
Common Wrapping Mistakes
- Wrapping only the goods means the entire load can slide off the pallet.
- Loosely applied film provides almost no resistance to lateral shifting.
- Concentrating film in the middle leaves the top and base unsecured.
- Film unravels if the end is not properly secured and hidden from forklifts.
Common Questions
Can I wrap a pallet with standard cling film?
No. Standard kitchen cling film tears too easily under freight conditions. Use industrial pallet stretch wrap, which has significantly greater stretch and tear resistance. It's inexpensive and available from most packaging or builders' suppliers.
Should I add strapping over the stretch film?
For loads exceeding 500 kg, particularly tall loads, or shipments going on longer routes, plastic or metal strapping over the stretch film provides additional security. Apply strapping over the top of the pallet and down through the pallet deck to prevent the load lifting off the deck on impact.




