A poorly stacked pallet is one of the most common reasons for freight damage claims. When boxes shift during transit, they crush each other, fall against the trailer walls, or topple when a forklift lifts the pallet. Getting the stacking right takes only a few extra minutes and can be the difference between goods arriving intact and an insurance claim.
This guide explains the principles behind correct pallet stacking, the two main stacking patterns, and what to check before the driver arrives for collection.
The Core Principle: Heavy at the Bottom
The fundamental rule of pallet stacking is straightforward: heaviest items go at the bottom, lightest at the top. This keeps the centre of gravity low, reduces the chance of the load toppling, and prevents heavy boxes from crushing lighter ones beneath them.
Within each layer, place the heavier items towards the edges rather than the centre. This distributes weight more evenly across the pallet deck.
Column Stacking vs Brick Pattern
There are two main ways to arrange boxes on a pallet: column stacking and the brick (interlocking) pattern.
Column stacking
Boxes are stacked directly on top of each other in vertical columns. Because the weight transfers down through the box walls (the strongest part of a corrugated box), column stacking maximises the load-bearing capacity. The drawback is that layers are not interlocked, so the load is more vulnerable to tipping sideways.
Brick pattern (interlocking)
Boxes are staggered across layers, like brickwork, so each box spans the join between two boxes in the layer below. This creates a stable, interlocked structure that resists lateral movement. The trade-off is that box edges bear more load, which can weaken individual cartons over time — especially on longer journeys.
For most shipments, the brick pattern is the better choice because the lateral stability outweighs the slight reduction in per-box load capacity. For heavy industrial goods where individual box strength is critical, column stacking with added strapping provides the best combination.
Overhang Rules
Goods should not extend beyond the pallet edge. Most couriers enforce a maximum overhang of 20–30 mm (roughly the width of a thumb) on any side. Beyond this limit, the driver may refuse the collection.
If your boxes are slightly smaller than the pallet footprint, leave a small consistent gap at the edges rather than trying to fill the full deck — an unsupported overhang is more dangerous than a gap. Use void fill between the edges of boxes and the stretch film perimeter if necessary.
Securing the Load
Once stacked, the entire load must be secured with stretch film. Apply at least three to four passes of stretch film around the base of the boxes and over the top of the pallet deck itself — not just around the boxes — so that the film anchors the load to the pallet structure.
- Start each pass at the base of the pallet, wrapping around the deck as well as the goods
- Overlap each layer by at least 50% for a secure seal
- For heavy or high loads, consider plastic corner guards to protect box edges under film tension
- For very heavy loads, add pallet strapping (banding) over the top in addition to stretch film
Common Questions
Can I use a damaged pallet?
No. A pallet with broken boards, cracked stringers, or damaged deck blocks is a safety hazard and will likely be refused at collection. Always use an EPAL-stamped euro pallet in good condition, or a comparable certified industrial pallet.
What if my boxes are different sizes?
Start with the largest, heaviest boxes at the base to form a flat, stable layer. Build up with progressively smaller boxes, filling gaps with void fill where necessary. Avoid leaving unsupported spans in upper layers.
Get a Pallet Quote
Once your pallet is prepared, you can get instant courier quotes for pallet shipping from Cargosender. Enter your dimensions and weight to compare available services and book online.




